Description
Product Overview The 3500/40-01-00 is a 4‑channel Proximitor monitor for the classic Bently Nevada 3500 TSI machinery protection rack. It interfaces with eddy‑current proximity probes to measure radial shaft vibration, thrust position, gap, differential expansion and REBAM bearing wear. It computes direct, 1X amplitude and phase values, compares measurements against configurable Alert / Danger setpoints, sends alarm votes to relay modules and streams waveform and static data to System 1 for orbit and spectrum analysis. It follows API 670 and is widely used on steam turbines, gas turbines, centrifugal compressors and large pumps in power, refinery and offshore facilities.
Technical Specifications
- Manufacturer: Bently Nevada
- Model: 3500/40-01-00, front card PN: 176449-01, rear I/O PN: 125680-01
- Device Type: 4‑Channel Proximitor Monitor
- Channel count: 4 independent proximity input channels
- Supported transducers: Bently eddy‑current proximity probe systems (standard 5 mm, 8 mm, 11 mm, 14 mm probes)
- Measurement modes: Radial vibration, thrust position, shaft gap, differential expansion, REBAM
- Probe drive: Onboard -24 VDC transducer power
- Buffered output: Front‑panel BNC per channel for raw probe signal
- Frequency response: 4 Hz to 4000 Hz, user programmable filter
- Accuracy: ±0.25% of full scale typical
- Diagnostics: Probe open circuit, short circuit, transducer fault, signal out‑of‑range
- Indicators: OK, TX/RX, Bypass front LEDs
- Backplane: 3500 proprietary rack bus
- Power: Powered from rack backplane
- Operating temperature: -30°C ~ +65°C
- Storage temperature: -40°C ~ +85°C
- Humidity: 5% – 95% non‑condensing
- Form factor: Full‑height hot‑swap plug‑in monitor card
- Weight: Approx. 0.91 kg
- Certifications: CE, UL
- Feature: Supports TMR voting, latching alarms, waveform capture, configured via 3500 Rack Configuration Software
Differentiation Notes Suffix -01-00 denotes standard internal termination rear base without hazardous area certification. The newer 3500/40M is the SIL‑capable upgraded version. Distinguish from 3500/42 which is the velocity/seismic monitor for bearing housing vibration. This legacy 3500/40 is not interchangeable with 40M firmware and rear assemblies. Original production discontinued, available as NOS, refurbished and surplus spare parts.








Reviews
There are no reviews yet.