GE IS220PPDAH1A PPDA power distribution feedback I/O pack Mark VIe turbine control

  • Manufacturer: GE Vernova (GE Energy)
  • Model: IS220PPDAH1A
  • Device Type: PPDA Power Distribution Feedback I/O Pack
Categories: Tags:
Lily

Need help?
Email: sales@fyplc.cn
Tel/WhatsApp: +86 153 5945 8915

Description

Product Overview The IS220PPDAH1A is the PPDA Power Distribution Diagnostics / Power Distribution Feedback I/O Pack for GE Speedtronic Mark VIe turbine control system. It collects status and fault feedback signals from up to six JPD series power distribution terminal boards, monitors 28 VDC control power branches, ground faults, supply loss and relay circuit health. It transfers diagnostic data to the Mark VIe controller over redundant IONet Ethernet, and provides 1 ms SOE sequence-of-event timestamping for trip post-mortem analysis. It is widely deployed on gas turbines, steam turbines and centrifugal compressor protection cabinets in combined-cycle power plants.

Technical Specifications

  • Manufacturer: GE Vernova (GE Energy)
  • Model: IS220PPDAH1A
  • Device Type: PPDA Power Distribution Feedback I/O Pack
  • Platform: Speedtronic Mark VIe, paired with BPPB / BPPC controller packs
  • Network: 2 × 100BASE-TX RJ45 IONet redundant Ethernet ports
  • Supported terminal boards: Max 6 units (JPDC, JPDG, JPDM, JPDS)
  • Nominal supply: 28 VDC
  • SOE time resolution: 1 ms
  • Connector: 62-pin DC connector for JPDx terminal board interface
  • Diagnostics: Power rail monitoring, ground fault detection, circuit fault latching, module watchdog
  • Indicators: LEDs for PWR, ATTN, LINK, TX/RX status
  • Configuration: ControlST software, automatic electronic ID recognition
  • Hot swap: Hot-swappable in Mark VIe rack
  • Operating temperature: −40°C ~ +70°C
  • Humidity: 5% – 95% non‑condensing
  • Weight: Approx. 0.38 kg
  • Certifications: CE, IEC 61326‑1 EMC
  • Feature: Redundant IONet communication, hardware debounce for contact inputs, MOV surge protection, detailed fault counters for power circuit troubleshooting

Differentiation Notes IS220PPDAH1A is dedicated power distribution monitoring pack, different from general DI/DO packs such as IS220PDIAH1A / IS220PDOAH1A. It only works on Mark VIe IONet architecture and cannot be used on legacy Mark VI VME racks. IS220PPDAH1B is the updated hardware revision. Available as NOS, refurbished and surplus spare parts for turbine cabinet maintenance.

Reviews

There are no reviews yet.

Be the first to review “GE IS220PPDAH1A PPDA power distribution feedback I/O pack Mark VIe turbine control”

Your email address will not be published. Required fields are marked *

zzfyplc_Lily

Related products